Window tint can’t last forever. Over time, it wears and tears, and you will spot bubbles, peeling along the edges, separation of the tint film, and scratches all over its surface. Once the tint loses efficiency, stop protecting you from UV, and can’t keep the privacy of the inside of your car, you should remove it.
Fortunately, you won’t need a professional to remove window tint since it is a less demanding job than putting tint on the glass. I will list you a few excellent DIY methods to do the job on your own. Let’s go!
Reasons To Remove Window Tint
You can wish to remove window tint from your car for many reasons. However, three primary motives demand to finish this job as soon as possible.
No matter how well the window tint is applied, you will often face this problem after a while. Over time, you will see bubbles all over the film, which will make your windows look ugly. The reason is an unequal layer of adhesive applied.
Unfortunately, there is no way to fix this adequately. You can try to peel bubbles, but the result will be even worse, and your car will look less attractive than ever. The only efficient method to get rid of such tint is to remove all of it
If you decide to remove window tint from your car because you have bought the tinted vehicle or simply don’t want it anymore, you can do that. However, be prepared that it won’t be an easy task removing undamaged tint from the glass.
Over time, you will spot that your window tint turns purple once non-metallic dyes begin to breakdown. That is the sign that your tint can’t block UV rays anymore. Since you can’t repair this, it is the right time to replace the old tint.
1. How To Remove Window Tint With Hairdryer
- Glass cleaner
- Paper towels
- Knife or razor-blade
Using a hairdryer is an inexpensive and quick way to heat and remove window tint from window panes, especially when it starts damaging. You can also use a heat gun if you have any. The disadvantage of this method is that it can be a bit messy.
Turn on the hairdryer in the max setting and hold it approximately 2 inches (5 cm) away from the corner of the damaged tint you want to remove. After about 30 seconds, you can cut the corner of the tint with the knife.
Without turning off the hairdryer, continue peeling the tint. Try to direct the air stream to the parts where the window tint is most firmly attached to the glass. Then rub off the residue of adhesive with a clean towel and clean the windows entirely.
2. How To Remove Window Tint With Steamer Removal
- Adhesive remover
- Paper towels
Using a fabric steamer is probably the best, quickest, and cleanest method to remove window tint from the car windows. However, it will cost you some money if you need to rent the necessary equipment.
Start the procedure by filling the steamer with water. Then turn on the machine and hold the steam attachment about 1 inch (2.5 cm) close to a corner of the damaged tint. After a few minutes, you will see that glue melts, and you should try to remove the tint with the knife right away.
Start peeling the tint off while holding the steamer the same distance from the window. Always direct the steam to the piece of film you want to remove from the glass that moment. Finally, spray an adhesive remover and clean the window with the towel.
3. How To Remove Window Tint With Ammonia
- Dish soap
- Paper towels
- Knife it razor-blade
- Steel wool
- Plastic garbage bags
- Spray bottle
It is not the most pleasant way to remove window tint from your car glass, but it is highly efficient, especially during the sunny days. Well, the ammonia, in combination with heat, will soften the adhesive and become a practical solution against the window film for day and night privacy.
The first step is to prepare a soap solution and fill a spray bottle. Then cut a few plastic garbage bags. Pieces should be large enough to cover both the inside and outside parts of the window you want to clean.